Aurora Multimedia ASP-CATx1 Bedienungsanleitung PDF herunterladen (Seite 8)

~ 7 ~

1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit

ASP-CATX1-TX.

2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit ASP-CATX1-RX.

3. Connect IR Blaster/Receiver to both TX and RX units.

4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units.

5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose.

6. Plug in 5V DC power supply unit to the power jack of the receiving unit ASP-CATX1-RX.

7. Plug in 5V DC power supply unit to the power jack of the transmitting unit ASP-CATX1-TX.

8. If you see flickering or blinking image on the display, please adjust the rotary control switch to

improve the cable skew. 0 stands for the strongest HDMI signal level for longest possible

transmission length while 7 stands for the weakest HDMI signal level for short transmission

length. Please adjust the signal level from 7 to 0 and stop turning the rotary switch whenever

the audio/video is playing normally. Inappropriate signal level setting may cause overpowering

issue that would shorten the product life significantly!

1. Turn off ASP-CATX1-TX and disconnect the Cat.5/5e/6 between ASP-CATX1-TX and

ASP-CATX1-RX.

2. Connect the HDMI display to “HDMI IN” on the ASP-CATX1-TX with a HDMI cable.

3. Set “MODE” on the transmitting unit ASP-CATX1-TX at 7.

4. Turn on the ASP-CATX1-TX.

5. The LED on the RJ45 of ASP-CATX1-TX will dim and light again, which indicates the EDID

learning procedure is complete.

6. Unplug the HDMI cable from the display and follow the instruction in [Hardware Installation] to

set up the ASP-CATX1 and enjoy the experience.

Hardware Installation

EDID Learning

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Aurora Multimedia ASP-CATx1 Bedienungsanleitung Seite 8